For A Netserver In An Hp Rack - HP D5970A - NetServer - LCII Manual

Chapter 2
Figure 2-1. Remove NetServer Front Bezel (Pedestal Configuration)

For a NetServer in an HP Rack

For an HP NetServer in an HP rack, refer to the NetServer documentation and
your rack documentation as you do the following to remove the front bezel:
1. Ensure that all anti-tip and anti-roll features are installed and in use:
For HP Rack System racks and HP Rack System/E racks, extend
the anti-tip foot from under the front of the rack, and lower the four
leveler feet at the corners of the rack.
For HP Rack System/U racks, ensure that the anti-tip feature is
attached, and lower the four leveler feet at the corners of the rack.
Installation
9