HP D5970A - NetServer - LCII Manual page 15

Chapter 2
Figure 2-3. Remove Front Bezel from NetServer in HP Rack
5. Unscrew the NetServer chassis from the front of the HP rack, as follows:
a. Remove two screws securing the bezel hinge to the rack, as shown in
Figures 2-4 and 2-5. Do not unscrew the entire hinge from the chassis;
remove only the outer screws, so the hinge remains attached to the
NetServer chassis.
b. Remove two screws securing the bezel latch assembly to the rack, as
shown in Figures 2-4 and 2-5. Do not unscrew the entire assembly from
the chassis; remove only the outer screws, so the latch assembly
remains attached to the NetServer chassis.
Installation
11