Type 1 And Type 2--Mounting The Hp Netserver Lh 3R In The Rack - HP LC2000r - NetServer - 128 MB RAM User Manual

Chapter 8
Note which rack type you have and follow the instructions for your version.
Table 8-1. The Two Rack Types Compared
Rack Feature
Product Nameplate
Front and Rear Doors
Outside Panels
Column Cross Section
(See Figure 8-3)
Marking of EIA Units
Anti-Tip Foot
Columns Attached to Base
You can mount the HP NetServer LH 3r in either the Type 1 rack (HP Rack
System/E) or in the Type 2 rack (HP Rack Systems). The procedures for
mounting are similar, except that there are two different templates included and
the mounting slides fasten to the rear columns differently.
Type 1 and Type 2--Mounting the HP NetServer LH
3r in the Rack
NOTE
If you want to put your NetServer into a third-party rack, you
may be able to find relevant documentation on HP's web site at
the following URL:
http://www.hp.com/netserver/servsup
1. First, determine and mark the height at which the NetServer is to be
located in the rack enclosure.
Use the original ordering information to locate where each component
goes in the rack. See Figure 8-4.
If the original ordering information is not available, use HP rack
configuration tools to plan the location of the components.
You can also use the HP NetServer rack configuration tools to make
ordering easier and to automatically check that orders are complete. These
tools can be found on the HP web site. Use the Search function with the
words "rack configuration tools" at the following URL:
http://www.hp.com/go/netserver
Mounting the NetServer in a Rack
Type 1
Hewlett Packard Rack System/E
Curved
Plastic and Modular
5-Cornered
Numbers Stamped in Metal
Extends from Front or Rear
Offset from Edge of Base
Type 2
Hewlett Packard HP Systems
Flat
Sheet Metal and Full-Length
3-Cornered
Triangular Cut Outs
Extends from Front Only
Flush with Edge of Base
45