Extending The Hp Netserver Lh 3R From The Rack - HP D7171A - NetServer - LPr Installation Manual

Chapter 1

Extending the HP NetServer LH 3r from the Rack

Extend the NetServer chassis from the rack to access the cover panels and system
board.
WARNING Do not unscrew the NetServer until you have extended the
anti-tip foot from under the front of the rack. This anti-tip
device must be extended to prevent the rack and NetServer
from tipping over, which could damage the NetServer and
injure people.
1. Unscrew the NetServer chassis from the rack, as shown in Figure 1-4. Do
not unscrew the entire hinge or bracket from the chassis; remove only the
outer screws, so the hinge and the bracket remain attached to the
NetServer chassis (see Figure 1-5).
2. Pull the NetServer forward from the rack until the lockout device engages
with a click.
Figure 1-4. Releasing the HP NetServer LH 3r Chassis From the Rack
Processor Module Installation
7