4.
As shown below, squeeze and hold the two green mounting rail release tabs toward each other
(1), and then slide the hard drive out of the chassis (2).
Figure 4-42
5.
Remove the hard drive body from the mounting rails, as shown in the following figure.
Figure 4-43
Installing a SAS hard drive
NOTE:
Each workstation hard drive bay can be configured at the factory to hold three small form factor
hard drives instead of two standard size drives. To obtain the option kit documentation for removal and
replacement of small form factor hard drives, refer to the HP xw Workstation series - Small form factor
bay converter and hard drive installation user guide at:
88
Chapter 4 Removal and replacement procedures
Removing the SAS hard drive
Removing the hard drive body from the mounting rails
http://www.hp.com/support/xw6600
manuals.
ENWW