Installing A System Processor - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

3. Raise the processor socket lever (1) and open the cover (2), as shown:
Figure 4-59
CAUTION:
extreme care when handling the processor.
4. Pull the processor straight out of the socket (3), making sure not to touch the processor socket pins
or the gold pads underneath the processor, and handling the processor by the edges.
5. Store the processor in a static free container in a safe place.

Installing a system processor

1. Disconnect power from the system (see
2. Remove the side access panel (see
3. Remove the processor heatsink (see
4. Remove the processor (see
5. Raise the processor socket lever and cover fully.
6. If adding second processor to a workstation that originally contained only one, remove the plastic
cover from second processor socket
CAUTION:
extreme care when installing the processor in the socket.
ENWW
Removing the system processor
The processor socket contacts are delicate. To avoid bending the contacts, use
Removing a system processor on page
The processor socket contacts are delicate. To avoid bending the contacts, use
Predisassembly procedures on page
Side access panel on page
Removing the processor heatsink on page
Removing and replacing components
52).
58).
96).
98).
99