HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual page 142

Table 5-18 POST error messages (continued)
Screen message
514—CPU or Chassis Fan not
detected
515—CPU Overtemp ocurrred Insufficient processor cooling, or
516—PCI fan not detected
517—Low power CPU
heatsink(s) detected for high
power CPUs
518—Power supply wattage
insufficient for hardware
configuration
601—Diskette Controller Error Diskette controller circuitry or diskette
605—Diskette Drive Type
Error
610—External Storage Device
Failure
912—Computer Cover Has
Been Removed Since Last
System Start Up
914— Hood Lock Coil is not
Connected
921—Device in PCI Express
Slot failed to initialize
922—Fatal error in slot #
132 Chapter 5 System diagnostics and troubleshooting
Probable cause
CPU or chassis fan is missing, not
connected, or defective
processor defect
Missing PCI fan, or disconnected fan
cable
Inadequate heatsink installed
Workstation configuration requires
more power than the power supply can
provide
drive circuitry incorrect
Mismatch in drive type
External storage device not detected,
improperly connected, or defective
N/A
Mechanism is missing or not
connected
Missing, improperly seated, or
defective card
Fatal error occurred in the designated
slot
Recommended action
1. Insure the processor or chassis fan is installed and
connected properly.
2. Replace the processor fan or the chassis fan.
1. If necessary, add a heatsink to processor and
ensure proper operation.
2. Replace the processor.
● Add a PCI fan if necessary.
● Insure proper PCI fan cable connection and
operation.
Replace the low power heatsink with a high power
heatsink.
● Reduce the workstation power consumption.
● Replace the power supply with a high output
power supply.
1. Run the Computer Setup (F10) utiltiy.
2. Verify cabling and replace defective cables if
necessary.
3. Clear CMOS.
4. Replace diskette drive.
5. Replace the system board.
1. Run the Computer Setup (F10) Utility.
2. Disconnect any other diskette controller devices
(tape drives).
3. Clear the CMOS.
1. Ensure the external device is present and
connected properly.
2. Replace the external device.
No action required.
1. Reconnect or replace the missing mechanism.
2. Reseat or replace the missing mechanism cable.
1. Ensure the card is installed.
2. Reseat the card.
3. Replace the card.
Move the card to a different slot. If the problem persists,
replace the card.
ENWW