Installing An Optical Drive - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

5. Lift the green drive-lock release lever (1) and gently slide the drive out of the chassis (2), as shown
in the following figure.
Figure 4-18
6. If you are not replacing this drive or installing another optical drive before workstation operation,
add a bezel blank filler to the front bezel and an EMI filler to the optical drive slot.

Installing an optical drive

1. Disconnect power from the system (see
2. Remove the side access panel (see
3. Remove the front bezel (see
4. Remove the blank filler in the front bezel (if still installed) for the drive bay in which you are installing
the optical drive.
5. Remove the EMI filler from the optical drive cage where the device will be installed.
68 Chapter 4 Removal and replacement procedures
Removing the optical drive from the chassis
Removing the front bezel on page
Predisassembly procedures on page
Side access panel on page
52).
58).
61).
ENWW