HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual page 141

Table 5-18 POST error messages (continued)
Screen message
210—Mismatched memory
(AMBs) detected
211—Memory warning
condition detected
212—Failed Processor
213—Incompatible Memory
Modules
214—DIMM Configuration
Warning
216—Memory Size Exceeds
Maximum Supported
301—Keyboard Error
303—Keyboard Controller
Error
304—Keyboard or System
Unit Error
510—Splash Screen image
corrupted
511—CPU. CPU A, or CPU B
Fan not detected
512—Chassis, rear chassis, or
front chassis fan not detected
513—Memory fan not
detected
ENWW
Probable cause
Different memory module types are
matched
Improper or defective memory module Replace the memory module.
Processor has failed to initialize.
A memory module in memory socket
identified in the error message is
missing critical SPD information, or is
incompatible with the chipset.
DIMMs are not installed correctly (not
paired correctly)
The amount of memory installed
exceeds that supported by the
hardware
Keyboard failure.
I/O board keyboard controller is
defective or is not set properly
Keyboard failure.
Splash Screen image has errors.
Fan is not connected or is defective
Fan is not connected, might have
malfunctioned.
Missing or disconnected memory fan
Recommended action
Ensure that compatible memory module types are used
in matched pairs.
1. Reseat the processor in its socket.
2. If the processor does not respond, replace it.
1. Verify proper memory module type.
2. Insert the DIMM in another memory socket.
3. Replace module with a DIM conforming to the
SPD standard.
See the service label on the workstation access panel
for the correct memory configurations, and reseat the
DIMMs accordingly.
1. Verify how much memory your system supports.
2. Remove the excess memory.
1. Reconnect the keyboard with the workstation
powered off.
2. Check the connector for bent or missing pins.
3. Be sure that none of the keys are pressed.
4. Replace the keyboard.
1. Reconnect the keyboard with workstation
turned off.
2. Replace the system board.
1. Reconnect the keyboard with workstation turned
off.
2. Be sure that none of the keys are pressed.
3. Replace keyboard.
4. Replace system board.
Update system BIOS.
1. Reseat the fan cable.
2. Reseat the fan.
3. Replace the fan.
1. Reseat the chassis, rear chassis, or front chassis
fan cable.
2. Reseat the chassis, rear chassis, or front
chassis fan.
3. Replace the chassis, rear chassis, or front
chassis fan.
1. Ensure the memory fan is installed.
2. Ensure proper memory fan connections.
POST error messages 131