4.10 Sound/FIR Board
Installing the Sound/FIR Board
To install the Sound/FIR Board, follow the steps below and refer to figures 4-24 and 4-25.
1. Connect the sound cable to PJ6000 on the sound/FIR board.
2. Fit the plastic cover onto the sound/FIR board.
3. Seat the sound/FIR board.
4. Seat the microphone in position.
CAUTION: Be careful to route the cable so that the Top cover will not pinch it. Make a
small loop on the board and set the microphone.
5. Secure the sound/FIR board with two M2 4 screws .
PORTEGE M100 Maintenance Manual (960-452)
4 Replacement Procedures
4-47