4.15 System Board
Installing the System Board
To install the system board, follow the steps below and refer to figures 4-35 to 4-37.
1. Seat the system board.
2. Connect the system board to PJ9500 on the I/O board.
3. Route the Modem/LAN cable through the notch of the system board.
4. Connect the MDC cable to the connector PJ 3022 and Modem/LAN cable to the
connector PJ3021/PJ4101 on the system board.
5. Secure the cables with glass tape s.
CAUTION: Make sure the cable lies inside the notch. Be careful not to damage or pinch
the cables when you seat the system board in the bottom case.
Secure the cable with a glass tape referring to Figure 4-37.
Be careful not to lay the cable on the lead of DIP of the RJ11/RJ45
connector.
PORTEGE M100 Maintenance Manual (960-452)
Figure 4-37 Seating the cables
4 Replacement Procedures
4-57