HP Vectra VE 6/xxx - 8 Maintenance Manual page 58

NOTE
2 How to Install Accessories in Your Minitower PC
Installing Accessory Boards
8 The accessory board may need a special connection, such as:
Network cable to the WOL (Wake On LAN) connector.
•
Sound cable to the CD-ROM drive.
•
The following figure shows the location of the WOL connector.
WOL connector (already
connected for models with
a preinstalled LAN card)
For more information, refer to the documentation that came with
the accessory board. The necessary cables are usually provided with
the accessory board.
9 Install any other accessories before replacing the cover. Reconnect
all cables and power cords.
If you install a network board and connect it to the WOL
connector, you must enable the
program (
Advanced - Power Management Setup
network board supports this mode.
After you have installed certain types of accessory, for example,
a network board, you must reinstall Service Pack 3 (Windows
NT 4.0 only). You must also reinstall the drivers for the video
card. You can download the correct drivers from HP's Web site
at:
http://www.hp.com/go/vectrasupport/
48 English
field in the Setup
Wake On LAN
.
) if the