3.
Replace the screw that secures the access panel to the chassis (3).
Removing and Replacing the Battery
Before beginning the replacement process, review
on page 7
for procedures you should follow before and after installing or replacing hardware.
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1.
Locate the battery on the system board.
2.
To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
3.
To insert the new battery, slide one edge of the replacement battery under the holder's lip with the
positive side up. Push the other edge down until the clamp snaps over the other edge of the
battery (2).
12
Chapter 2 Hardware Changes
Before removing the side access panel, ensure that the thin client is turned off and the
General Hardware Installation Sequence