Installing A Rope Clip - IBM NetVista User Manual

7. Each integrated drive electronics (IDE) drive requires two cables; a four-wire
8. Clear any cables that might impede replacement of the drive cage.
9. Pivot the drive cage back into place.

Installing a rope clip

To help prevent hardware theft, you can add a 3/16-inch or 5-mm rope clip and
cable to your computer. After you add the security cable, make sure that it does
not interfere with other cables that are connected to the computer. For more
information about security, see Installing a cable lock in Access IBM.
To install a rope clip:
1. Remove the cover (see "Removing the cover" on page 17).
power cable that connects to the power supply, and a signal cable that connects
to the system board.
To connect a CD-ROM drive or DVD-ROM drive to your computer, follow
these steps:
a. Locate the signal cable that comes with your computer or with the new
drive.
b. Locate the secondary IDE connector on the system board. See "Identifying
parts on the system board" on page 18.
c. Connect one end of the signal cable to the secondary IDE connector on the
system board and the other to the CD-ROM drive or DVD-ROM drive.
d. Your computer has extra power connectors for connecting additional drives.
Connect the power cable to the drive.
What to do next:
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Replacing the cover and connecting the
cables" on page 28.
Chapter 2. Types 8303, 8304, and 8312
25