Changing The Battery - IBM NetVista User Manual

5. Thread the cable through the rope clip and around an object that is not a part

Changing the battery

Your computer has a special type of memory that maintains the date, time, and
settings for built-in features, such as parallel-port assignments (configuration). A
battery keeps this information active when you turn off the computer.
The battery normally requires no charging or maintenance throughout its life;
however, no battery lasts forever. If the battery fails, the date, time, and
configuration information (including passwords) are lost. An error message is
displayed when you turn on the computer.
Refer to "Lithium battery notice" on page vi for information about replacing and
disposing of the battery.
To change the battery:
of or permanently secured to the building structure or foundation, and from
which it cannot be removed; then fasten the cable ends together with a lock.
What to do next
v To work with another option, go to the appropriate section.
v To complete the installation, go to "Replacing the cover and connecting the
cables" on page 74.
1. Turn off the computer and all attached devices.
2. Remove the cover. See "Removing the cover" on page 61.
3. Locate the battery. See "Identifying parts on the system board" on page 63.
4. If necessary, remove any adapters that impede access to the battery. See
"Installing adapters" on page 65 for more information.
5. Remove the old battery.
6. Install the new battery.
7. Replace any adapters that were removed to gain access to the battery. See
"Installing adapters" on page 65 for instructions for replacing adapters.
8. Replace the cover, and plug in the power cord. See "Replacing the cover and
connecting the cables" on page 74.
Chapter 4. Types 8307, 8308, 8310, 8311, 8314, and 8315
73