Charging Battery - Panasonic DMC-TZ3S - Lumix Digital Camera Operating Instructions Manual

1
Preparations
Battery (model-specific)
Charger
(model-specific)
Connect to charger.
(Ensure 'LUMIX' faces outwards.)
Charging light (CHARGE)
On: Charging in progress (approx. 120 min.)
Off: Charging complete
If light is flashing...
● Battery temperature is too high/too low → Battery may still be charged, but it will
take longer as it must adjust to the room temperature.
● Battery/charger connector is dirty → clean with dry cloth.
Approximate battery life
Number of pictures:
270 [300 2 ] (at 30-sec intervals)
1
Values based on CIPA standards. (P.91)
(Number reduced if intervals longer – 67 [75
Playback time: Approx. 260 [280
Above figures may be reduced if intervals between recording are longer; if flash, zoom,
or POWER LCD are used frequently; or in colder climates (depends on actual usage).
2
DMC-TZ2
Note
Battery will be warm during charging and for some time thereafter.
Battery will run out if not used for long periods of time, even after being charged.
Battery can be topped up even if not fully depleted.
Do not disassemble or modify the charger.
Please purchase a new battery if battery life becomes significantly reduced.
14
VQT1B61

Charging battery

Always charge before first use! (not sold pre-charged)
Fold out pins and
plug into electrical outlet.
Disconnect charger and
battery when charging is
complete.
1 (equivalent to approx. 135 [150
2
] mins
Indoor electrical outlet
(charge at room temperature of 10-
35°C (50°F-95°F))
2
] pictures if 2-minute intervals)
plug
2 ] mins)