Error Code List - NEC NC900C Installation Manual

Appendix

5-2. Error Code List

Please inquire your dealer/distributor about action to be taken for each error code.
Error Code
4 GPSU(12V) Fail
5 Lamp Unlit
12 E2PROM R Fail
15 E2PROM W Fail
120 DLP Ack Fail
121 Lens Fail
140 DLP CommR Fail
141 DLP CommE Fail
151 Fan1 Stop
152 Fan2 Stop
153 Fan3 Stop
154 Fan4 Stop
155 Fan5 Stop
156 Fan6 Stop
157 Fan7 Stop
158 Fan8 Stop
159 Fan9 Stop
164 ICP Fan Stop
165 GPI MACRO(n) Selection Invalid
166 GPI Control Invalid
177 Tamper Fail
178 Marriage Tamper Fail
180 CPU Fail(Mem)
201 Error Log Write Fail
215 Filter Time Over
220 AC On Fan Exchange Time
230 Router Fail
232 MAC Write Fail
235 Router Self Check Fail
240 SIB Comm Fail
241 SIB Error
242 SIB FPGA Reboot
245 Fan10 Stop
246 Fan11 Stop
247 Fan12 Stop
248 Fan13 Stop
249 Fan14 Stop
251 Fan1 Stop Precaution
252 Fan2 Stop Precaution
253 Fan3 Stop Precaution
254 Fan4 Stop Precaution
255 Fan5 Stop Precaution
256 Fan6 Stop Precaution
257 Fan7 Stop Precaution
82
Error message Description
Power supply is abnormal.
Lamp doesn't light up.
E2PROM data read error is detected.
E2PROM data write error is detected.
ICP failed operation. It could be caused by configuration
files lost, disk space issue, or DISKCHIP corruption issue.
Lens unit control error
No communication with the ICP board.
(Communication I/F is RS-232C)
No communication with the ICP board and DCC.
(Communication I/F is Ethernet)
Fan1 has stopped.
Fan2 has stopped.
Fan3 has stopped.
Fan4 has stopped.
Fan5 has stopped.
Fan6 has stopped.
Fan7 has stopped.
Fan8 has stopped.
Fan9 has stopped.
ICP Fan has stopped.
Selection of preset button (n) through GPI is invalid
because metadata is enabled.
Projector control through GPI is invalid because projector
is busy.
Service door tamper switch of projector is open.
Marriage tamper switch of projector is open.
System Test Failed during lamp on. (Memory)
Failed to write error log.
The time to exchange filters.
The time to exchange filters.
The time to exchange fans.
Failed to control router.
Failed to setup MAC address of CPU board.
Router health-check error.
Failed to communicate with SIB.
SIB internal error.
Executed to re-boot SIB FPGA for recovery.
Fan10 has stopped.
Fan11 has stopped.
Fan12 has stopped.
Fan13 has stopped.
Fan14 has stopped.
Fan1 Stop Precaution.
Fan2 Stop Precaution.
Fan3 Stop Precaution.
Fan4 Stop Precaution.
Fan5 Stop Precaution.
Fan6 Stop Precaution.
Fan7 Stop Precaution.