NEC NC900C Installation Manual page 33

AC power supply cable for the projector
The projector is equipped with an IEC60320 C19 connector to connect an AC power supply cable. Ensure that the AC power
cables that connect the connectors built into the projector to the AC power mains have the current capacities as shown below.
Power supply voltage
AC 100–130V
AC 200–240V
Furthermore, use plugs, cables, and connectors that are suitable for the regulations of the country of installation, as shown in
the following table.
For users in North America
NOTE
Use a power cable no longer than 4.5m/14.76 ft according to National Electrical Code.
Germany
Plug
CEE 7
USA
Plug
NEMA 5-15P
Japan
Plug
JIS C 8303
China
Plug
GB2099
Projector input current
10.3 to 7.9A
5.1 to 4.3A
Plug
Cable
H05VV-F 3G1.5
Cable
SJT 3 x AWG 14
Cable
VCTF 3 x 2.0mm
Cable
RVV 300/500
125V 15A or higher
250V 15A or higher
250V 15A or higher
Cable
Connector
Connector
IEC 320 C19
Connector
IEC 320 C19
Connector
IEC 320 C19
Connector
GB17465.1
Setting Up Your Projector
Power cable current capacity
33