Security - Gigabyte GA-9ILDR User Manual

Security

Main Adv anced Boot
Set Superv isor Passw ord
Set User Passw ord
Passw ord Check
higf: Mov e Enter: Select +/-/PU/PD: Value
F5: Prev ious Values
When you select this function, the fol l owing message will appear at the center of the screen to assist
you in creating a password.
Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the
entered password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is
disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access
all BIOS Setup program function. When enabled, the Supervisor password is required for entering the
BIOS Setup program and having full configuration f i elds, the User password is required to access only
basic items.
If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be
prompted for the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Set u p" at "Password Check" in Advance BIOS Features Menu, you will be prompted
only when you try to enter Setup.
C Password Check
Select whether the password is required every ti m e when the system boots or only when user enter
the setup.
Phoenix -Aw ard WorkstationBIOS CMOS Setup Utility
Seccurity PC Health
[Setup]
F10: Sav e
F7: Optimized Defaults F8: Q-Flash
Figure 4: Security
57
BIOS Setup
Clk/Voltage Defaults
Item Help
ESC: Ex it F1: General Help
Ex it