Epson C323011 - TM J2000 B/W Inkjet Printer Installation Manual page 33

4. To check the port settings, select the [Ports] tab.
Check that the port is ESDPRTxxx and that the port matches the interface to which the
printer is connected.
Note : Note
Note Note
For port, specify an Epson Port (ESDPRTxxx). Do not specify a general-purpose port such as COM
or USB because the APD can be controlled only through the Epson Port.
5. In case of parallel or USB interface, click the [OK] button and close the Properties screen.
This is the end of the port settings.
6. For serial and TCP/IP interfaces, click the [Configure Port...] button.
7. The Configure Port screen appears. Check the port settings and click the [OK] button.
Serial
Configures the serial port communication settings. The [Restore Defaults] button
allows you to restore the original settings. When finished, click the [OK] button.
Rev.B
Advanced Printer Driver Installation Manual
APD Installation and Setup 2-15