Download
Share
Print this page
Epson C831 User Manual
  1. Manuals
  2. Brands
  3. Epson Manuals
  4. Printer Accessories
  5. C831
  6. User manual

Epson C831 User Manual

Longitudinal label slitter
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
USER MANUAL
Longitudinal Label Slitter
for EPSON C831
:
this product is certified

Advertisement

loading

Related Manuals for Epson C831

Summary of Contents for Epson C831

  • Page 1 USER MANUAL Longitudinal Label Slitter for EPSON C831 this product is certified...

  • Page 2: Installation

    INSTALLATION STEP 1 Assemble the printer plate. STEP 2 Connect the slitter to the printer plate. Label Unwinder (optional) STEP 3 Load the cardboard cores onto the core holder. STEP 4 Place the core holder in position. The grey handle must match with the grey holder.
  • Page 3 Paper Path Label face out Label face in Finished roll from Waste printer STEP 5 Attach the labels to the cores. This will provide the necessary tension in order start the slitting process. STEP 6 Align the blades with the edges and the center of the labels, tighten the thumb screw once the blade is in position.
  • Page 4 OPEN CLOSE Slitter module has 3 positions: - Upper position (A), the blades are closed to allow the media loading; - Middle position (B), align the blades with the edges and the center of the labels, tighten the thumb screw once the blade is in position; - Lower position (C), the blade cut the media.
  • Page 5 STEP 7 Switch on the Slitter. Slowly turn the speed knob. Run the slitter until the labels reach the bottom of the take-up core holder. Remove the labels that have rewinded onto the take-up core holder. STEP 8 Attach the labels to the core using a waste label or tape.
  • Page 6 REWINDER GUIDES ALIGNMENT Metal glides adjustable to obtain rolls of labels perfectly aligned. ULTRASONIC SENSOR CALIBRATION WARNING: Before proceeding with the ultrasonic sensor calibration, turn “OFF” the module that needs to be calibrated (laminating or matrix removing). 1. Take a paper clip and insert it into the little hole located next to the OFF-ON switch and push it down for 5 seconds.
  • Page 7 LAMINATION / MATRIX REMOVER & SLITTER MODULES SPEED ROTATION MATRIX REMOVER & SLITTER MODULE ULTRASONIC TENSION CONTROLLER WARNING: If what (pictured above) is not happening, please press the button on circuit board untill the yellow led flashes. After it flashes for 5 times release the button and perform a new test.
  • Page 8 smart solutions for the labeling industry Label rewinder, label unwinder, electronic label dispenser and more... - FOR MORE INFO CONTACT YOUR RESELLER -...