Playback; Preparations; Turning The Power On; Operations During Playback - Denon AVR 4308CI - AV Network Receiver Owner's Manual

<TUNING PRESET>
SOURCE SELECT <PHONES> <MASTER VOLUME>
<ON/STANDBY> <POWER>
[ AMP]
[POWER ON]
[POWER OFF]
[MASTER
VOLUME]
[MUTE]
[TUNER]
(AMP mode)
SOURCE
SELECT
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit


Playback

Preparations

Turning the Power On

1
<POWER>
Press .
The power indicator lights red and the power is set to the standby
mode.
2
<ON/STANDBY>
Press
The power indicator flashes green and the power turns on.
To operate the AVR-4308CI using the main remote control unit, set the
[ TU]
remote control unit to the AMP mode (vpage 64 "Remote Control
(DEVICE1 mode)
Unit Operations").
[A ~ G]
Turning the Power Off
[d f]
q Press <ON/STANDBY> or [POWER OFF].
[MEMO]
The power is set to the standby mode.
[MODE]
w Press <POWER>.
[BAND] The power indicator turns off, and so does the power.
NOTE
[CHANNEL]
Power continues to be supplied to some of the circuitry even when
the power is in the standby mode. When leaving home for long periods
of time or when traveling, either press <POWER> to turn off the power,
or unplug the power cord from the power outlet.
[1 ~ 8]

Operations During Playback

[SHIFT]
Adjusting the Master Volume
<MASTER VOLUME>
Either turn
VOLUME]
.
Turning Off the Sound Temporarily (Muting)
Press
To cancel, press [MUTE] again. Muting can also be canceled by adjusting
the master volume.
Listening with Headphones
Plug the headphones into
The sound from the speakers and pre-out connectors is automatically
cut.
NOTE
[POWER ON].
or
Be careful not to set the volume too high when using headphones.

Playing Video and Audio Equipment

Basic Operation

1
Prepare the equipment.
q Load the DVD, CD or other software in the player.
(vSee the operating instructions of the respective devices.)
w To play a video device, switch the monitor input.
(vSee the monitor's operating instructions.)
2
To operate using the main remote control unit, set the
remote control unit to the AMP mode.
(vpage 64 "Remote Control Unit Operations")
3
Use SOURCE SELECT to select the input source.
4
[MASTER
Start playback.
or press
(vSee the operating instructions of the respective devices.)
[MUTE]
.
<PHONES>
.
: "Source Select" (vpage 39, 40)