Setting Up The Remote - Hunter 28425 Installation & Operation Manual

4. Securely tighten all three screws.
5. Partially install the two #6-32 x 1/2" screws for the light fixture
as shown in Figure 25.
Light Fixture
Figure 25 - Installing the light fixture
6. Connect the plug connector from the fan to the plug connec-
tor on the light fixture.
NOTE: Use the large indentation in the center of the switch
housing to keep the wires and plug connectors out of the way
when assembling the light fixture.
7. Line up the key slots in the light fixture with the two partially
installed screws. Twist in place. Securely tighten both screws.
8. Install one A15, 60 Watt Max bulb.
9. Align the notches in both the glass globe and the light fixture.
Refer to Figure 26. Twist the glass clockwise to lock in place.
Knotches in
Light Fixture
and Glass
Globe
Glass Globe
Figure 26 - Installing the glass globe
installing without the light fixture
1. Partially install two of the #6-32 x 3/8" screws into the mount-
ing plate as shown in Figure 24.
2. Insert the plug connector from the fan through the hole in the
switch housing as shown in Figure 24.
3. Line up the key slots in the switch housing with the two par-
tially installed screws. Twist in place. Line up the third hole
and insert the screw.
4. Securely tighten all three screws.
5. Align the holes in the switch housing cover with the holes in
the switch housing as shown in Figure 27. Securely tighten a
#6-32 x 1/2" screw in each hole.
6. Insert the finial through the cap and screw the finial into the
switch housing cover as shown in Figure 27.
© 2005 Hunter Fan Company
Switch Housing

setting up the remote

F F F F F C C C C C C I
1.
2.
•
•
•
•
3.
4.
Figure 27 - Installing without the light fixture
C In n n n n f f f f f o o o o o r r r r r m m m m m a a a a a t t t t t i i i i i o o o o o n n n n n C I C I C I
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
NOTE: Any changes or modifications to the transmitter or
receiver not expressly approved by Hunter Fan Company may
void one's authority to operate this remote control.
For use only with electrically reversible ceiling fans rated at 1.0
amp or less, and fan incandescent light kits rated at 300 watts
or less.
Not for use with shaded-pole or nonreversible motors. Not
recommended for use with the Hunter Original
Switch Housing Cover
Cap
Finial
® .
41860-01 02/24/2005
9 9 9 9 9