Setting The Remote Transmitter; And Receiver - Hunter TYPE 3 Installation And Operation Manual

4 • Setting the Remote Transmitter and Receiver
Setting Dipswitches
When two or more fans are located near each other, you may desire
to have the receiver/transmitter for each fan set to a different code,
so that the operation of one fan does not affect the operation of the
other fans.
The dipswitches for the receiver are located on the flat surface of the
receiver. The dipswitches for the transmitter are in the the battery
compartment.
4-1. IMPORTANT! Before you change the dipswitch settings, make
sure the battery is not connected to the transmitter.
Change the position of the dipswitches in the remote transmitter
and the receiver. Make sure that the dipswitches match in
the remote receiver and transmitter. If they don't match, the
transmitter will not function.
4-2. Install the included 9-volt battery into the transmitter.
CAUTION: The remote control device complies with part 15 of the FCC rules.
Changes or modifications not expressly approved by Hunter Fan Company could void
your authority to operate this equipment.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
WARNING: Use only the Hunter Fan speed control supplied with this fan.
4-3. Raise the fan and align the slots in the canopy with the hooks
on the ceiling plate.
Note: To hang the fan, you must tilt the canopy to an almost
vertical position so that the canopy slots sit on the ceiling
plate hooks.

42756-01 • 06/26/07 • Hunter Fan Company
Receiver Dipswitches
Transmitter Dipswitches
Example Dipswitch Settings
Receiver 1 Receiver 2
Dip Switches Dip Switches
Set to 01110 Set to 01001
Transmitter 1 Transmitter 2
Dip Switches Dip Switches
Set to 01110 Set to 01001