Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Hunter 28425
Summary of Contents for Hunter 28425
- Page 1 © 2004 Hunter Fan Company 41860-01 02/24/2005...
-
Page 2: Cautions And Warnings
A longer downrod may need to be purchased for ceilings higher ® than 9 feet. If you need help installing the fan, your Hunter fan dealer can di- rect you to a licensed installer or electrician. Your new Hunter ®... -
Page 3: Preparing The Fan Site
Hunter fan. F F F F F i i i i i g g g g g ur ur ur ur ure 3 - M... -
Page 4: Preparing The Wiring
Your fan comes with four neoprene noise isolators. Position the isolators between the ceiling plate and ceiling by inserting the raised areas on each isolator into the holes in the ceiling plate. Refer to Figure 8. 41860-01 02/24/2005 © 2005 Hunter Fan Company... -
Page 5: Assembling The Fan
© 2005 Hunter Fan Company 41860-01 02/24/2005... -
Page 6: Hanging The Fan
..n in Loop Hook Figure 13 - Installing the adapter cover Figure 14 - Hanging the fan 41860-01 02/24/2005 © 2005 Hunter Fan Company... -
Page 7: Wiring The Fan
To remove the canopy trim ring, press firmly on opposite sides of the ring towards the canopy as shown in Figure 19. The tabs will flex out releasing the trim ring from the canopy. © 2005 Hunter Fan Company 41860-01 02/24/2005... -
Page 8: Assembling The Blades
Figure 19 - Removing the canopy trim ring assembling the blades Medallion Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan). Your fan may include blade grommets. If your fan has grom-... -
Page 9: Setting Up The Remote
NOTE: Any changes or modifications to the transmitter or switch housing as shown in Figure 24. receiver not expressly approved by Hunter Fan Company may Line up the key slots in the switch housing with the two par- void one’s authority to operate this remote control. - Page 10 Dip Switches Compartment Figure 29 - Installing the remote cradle on a rocker light switch Cover Continue to in installing the battery. Figure 31 - Installing the battery and setting the dip switches 41860-01 02/24/2005 © 2005 Hunter Fan Company...
- Page 11 Refer to Figure 34. last dip switch code setting. The setting will not change in the event of power failure or if power to the fan is inadvertently shut off. Figure 34 - Air flow patterns © 2005 Hunter Fan Company 41860-01 02/24/2005...
-
Page 12: Troubleshooting
If you need parts or service assistance, please call 888-830-1326 or visit us at our WEB site at http://www.hunterfan.com. Hunter Fan Company 2500 Frisco Avenue Memphis, Tennessee 38114 41860-01 02/24/2005 © 2005 Hunter Fan Company...