Eizo FlexScan F930 User Manual page 20

Power saving method of VESA DPMS and the monitor
VESA DPMS utilizes four signals: ON, STAND-BY, SUSPEND, and OFF. The
monitor detects these signals from the graphics board and executes power-saving
accordingly, as shown in the table below.
Signal
ON
STAND-BY
SUSPEND
OFF
2. Power-save Setup (To set the period in which the monitor will be in
operation)
The Off Timer function allows the user to set the time in which the monitor will be in
operation, called the "On Period" and automatically shifts the operation into the "Off
Timer Mode" when the set "On Period" expires. The energy consumption of the
monitor in the "Off Timer Mode" is as low as the one of the monitor in "PowerManger
Mode 2" although no setting PC to operate the Off Timer function is required.
Advance notice (LED flashing green) will be given 15 minutes before the monitor
automatically enters the "Off Timer Mode".
· To delay entering the "Off Timer Mode", press any keys on the front panel located to
the left of the power switch during the "Advance notice Mode". The monitor will
continue to operate for an additional 90 minutes. There will be another advance notice
for 15 minutes as described. Delayed entrance into the "Off Timer Mode" can be
extended as many times as desired.
20
2 SCREEN ADJUSTMENT
Procedure
1) First, make the appropriate settings for the PC.
2) Select "On" in the "PowerManager" menu.
Screen
Operation
Blank
Blank (Mode 1)
Blank (Mode 2)
Procedure
1) Select the "Off Timer" icon. Select "Enable" and press the
enter key.
2) Press the right/left key to adjust how long (0 to 23 hours) the
monitor should be in the "On Period". Choosing 0 disables the
"Off Timer".
LED Power consumption
Green
Green
Flashing green
Yellow
130 W (normal)
80% of normal
less than 10 W
less than 3 W