Eizo ColorEdge CG210 User Manual page 47

If a problem persists even after applying the suggested remedies, contact an EIZO
dealer.
No picture problems : See No.1 ~ No.2
Imaging problems : See No.3 ~ No.14
Other problems : See No.15 ~ No.18
USB problems : See No.19 ~ No.20
Problems
1. No picture
Indicator status: Off
Indicator status: Blue
Indicator status: Yellow
Indicator status: Slowly flashing
Yellow
2. Following messages
appear. (Error messages
shown below will remain
on the screen for 40
seconds.)
Points to check with possible solutions
[ ] Check that the power cord is correctly
connected. If the problem persists, turn off
the monitor power for a few minutes, then
turn it back on and try again.
[ ] Check the Gain setting.
[ ] Switch the signal Input by pressing the input
signal selection button on the front control
panel.
[ ] Try pressing a key on the keyboard, or
clicking the mouse.
[ ] Try turning the PC on.
[ ] Try pressing the power button
These messages appear when the signal is not
inputted correctly, even if the monitor
functions properly.
[ ] When the image is displayed correctly after a
short time, there is no problem with the
monitor. (Some PCs do not output the signal
soon after powering on.)
[ ] Check that the PC is turned ON.
[ ] Check that the signal cable is properly
connected the PC or graphics board.
[ ] Switch the signal input by pressing the Input
Signal Selection button on the front control
panel.