Xerox DocuPrint 155 Troubleshooting Manual page 55

Troubleshooting Guide
Figure 6-2. Three registration transport roll levers on
system with 7 by 10-inch enablement kit
a. Lever 1: Left - Maximum Pressure setting
b. Lever 2: Right - Maximum Pressure setting
c. Lever 3: Right - Maximum Pressure setting
4. When the print job is complete, return the levers to their
normal position.
5. Close the doors.
NOTE: Here are a few things for adjusting the registration
transport roll lever:
• Position all levers for the same (either minimum or maximum)
pressure setting. Do not intermix the positions of the levers.
• Paper greater than 14 inches / 352 mm in any dimension is
considered oversized.
• Paper heaver than 24 pounds / 90 gsm is considered heavy
weight.
• The following factors may affect the positioning of the paper
levers:
– Machine tolerance
– Paper supplier
– Job type (e.g., duplex).(clockwise).
Optimizing print quality
6-3