Operating Components Not Reached By The Remote Controller Signals (Ir In) - Integra NAC-2.3 Instruction Manual

Connecting the NAC-2.3
Operating components not reached by the remote controller signals
(IR IN)
The following equipment (sold separately) is essential for operation:
Onkyo's Multi-Room System kits (IR Remote Controller Extension System), or
Multiroom A/V distribution and control systems from Niles
If the remote controller signal does not reach the NAC-2.3 remote sensor
If the NAC-2.3 is located inside a cabinet or other enclosure where the infrared rays from the remote
controller cannot enter, then operation with the remote controller will not be possible. In such a case, it
will be necessary to install a remote sensor at a location outside of the cabinet for the infrared rays from
the controller to reach.
IR IN
Make connection as shown below. Do not plug the equipment into the power source until the
connection is complete.
Connecting
block
NAC-2.3
Remote controller
In the
cabinet
Signal flow
Mini plug
cable
IR
IN
NAC-2.3
® ®
and Xantech
IR Receiver
From connecting
block
to name a few.
25