Connecting Speaker Systems - Integra NAC-2.3 Instruction Manual

Connecting the NAC-2.3

Connecting speaker systems

Before connecting
• The load impedance of each speaker must be at least 6 Ω.
• Do not use unnecessarily long or extremely thin speaker cords. Otherwise, the DC resistance of the
speaker cords may become too high, lowering the damping factor and causing the sound quality to
deteriorate.
• Do not connect the speaker cord to the L and R connectors at the same time and do not connect two
or more speakers to the same speaker connectors.
Preparing the speaker cords for connection
1. Strip 15 mm from
the end of each
cord.
5/8"
(15mm)
Connecting the speaker cords to the speaker connectors
Right
speaker
24
R L
2. Twist the stripped
end of the cord.
R L
NAC-2.3
ANTENNA
SPEAKERS
FM
( 6 OHMS MIN. )
AM 75
ETHERNET
R L
OSD AUX FIXED VARIABLE
OUT IN OUT OUT
L L
IR
IN
R R
R
Note:
To prevent damage to
circuits never short-
circuit the positive (+)
and negative (–)
speaker wires.
1. Press down the lever.
Left
speaker
2. Insert the wire into the
3. Release the lever to
AUDIO NETWORK RECEIVER
NAC- 2.3
MODEL NO.
AC INLET
L
hole.
replace it.