Dell PowerEdge C8000 Hardware Owner's Manual page 216

3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 210.
4 Remove the heat sink. See "Removing a Heat Sink" on page 212.
CAUTION:
that the release lever can spring up suddenly if not firmly grasped.
5 Position your thumb firmly over the processor hook-shaped socket-release
lever and release the lever from the locked position. Do not force the lever
up to the fully open position. See Figure 3-59.
6 Position your thumb firmly over the bent load lever and release the lever
from the locked position. Rotate the lever 90 degrees upward to lift the
processor shield. See Figure 3-59.
7 Rotate the processor shield upward and out of the way. See Figure 3-59.
8 Lift the processor out of the socket and leave the socket-release lever and
load lever up so that the socket is ready for the new processor. See
Figure 3-59.
CAUTION:
that the release and load levers can spring up suddenly if not firmly grasped.
Figure 3-59. Removing and Installing a Processor
216
Installing System Components
The processor is held in its socket under strong pressure. Be aware
The processor is held in its socket under strong pressure. Be aware