3 Remove the three screws securing the hard-drive LED board assembly. See
Figure 3-31.
4 Pull the hard-drive LED board assembly away from the front cover. See
Figure 3-31.
Figure 3-31. Removing and Installing the Hard-Drive LED Board Assembly
1
1
screws (3)
Installing the Hard-Drive LED Board Assembly
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Align the hard-drive LED board assembly with the screw holes on the front
cover. See Figure 3-31.
2 Replace the three screws securing the hard-drive LED board assembly to
the front cover. See Figure 3-31.
3 Close the sled. See "Installing the Front and Back Sled Covers" on
page 165.
4 Replace the sled. See "Installing a Sled" on page 142.
174
Installing System Components
Many repairs may only be done by a certified service technician. You
2
hard-drive LED board assembly
2