Figure 3-16. Removing and Installing a Hard-Drive Carrier Located in the Sled Cover
1
strap handle
Installing a Hard-Drive Carrier on the Sled Cover
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Align the hard-drive carrier to the drive bay, and then slide the hard-drive
carrier into the drive bay until the drive is fully seated. See Figure 3-16.
2 Insert the drive-bay cover into the notch on the sled cover and close the
drive-bay cover. See Figure 3-15.
3 Push the cover down until it snaps into place. See Figure 3-15.
4 Replace the sled. See "Installing a Sled" on page 142.
152
Installing System Components
1
Many repairs may only be done by a certified service technician. You
2
2.5-inch hard-drive carrier
2