Installing The Sled Cover - Dell PowerEdge C8000 Hardware Owner's Manual

Figure 3-27. Removing and Installing the Sled Cover
1 sled cover screws (4)
3 twin axial cable screw
5 cable retaining clip

Installing the Sled Cover

NOTE:
It is recommended that you always use a static mat and static strap while
working on components in the interior of the system.
1 Connect the twin axial cable to the system board. See Figure 3-27.
2 Replace the screw securing the twin axial cable to the system board. See
Figure 3-27.
3 Connect the emergency throttling cable labeled NPDB for GPGPU to the
node power distribution board on the sled tray. See Figure 3-26.
Make sure the emergency throttling cable labeled PS-ON is connected to
the node power distribution board on the sled cover. See Figure 3-26.
4 Route the emergency throttling cable properly and secure it to the sled
cover's retaining clip.
168
Installing System Components
2 sled cover
4 twin axial cable