Operation; Issuing Printing Commands - Kyocera KM-4230 Instruction Handbook Manual

5. Operation

(1) Issuing printing commands

Carry out the following procedure in order to issue printing commands from your
computer and print out with this unit.
Turn the main switch ON ( | ).
1
* The basic copier screen will appear on the touch panel and, once warm up is
complete, "Ready to copy." will appear in the message display.
Press the Copier/Printer switching key to switch to the screen for printer operation.
2
* If printing commands are issued from your computer immediately after a copy job
is completed in this unit, the print job may not be started right away. This is because
the copying settings must be cleared in this unit before printing can begin. Once
the Auto Clear function engages and copy settings are cleared, printing will begin.
To initiate printing immediately, press the Copy/Printer switching key to change to
the screen for printer operation.
Press the "To on line" key and "Ready to print." will appear in the message display.
3
This will signify that the printer is on-line.
* It is not necessary to press the "To on line" key if "Ready to print." is already dis-
played.
In your computer, start up the software application to be used.
4
* Carry out the printing procedure appropriate to the software application in use. For
more detailed information, refer to the Instruction Manual for the software applica-
tion in use.
* DO NOT return to the screen for copier operation and press the Stop/Clear key
during printing. If you do, printing will be canceled.
13