When This Message Is Displayed - Kyocera KM-4230 Instruction Handbook Manual

7. When This Message is Displayed...

If one of the following messages appears on the touch panel, verify the content of the message and perform the appropriate procedure. At the
same time, refer to the Instruction Handbook for your copier or the Instruction Handbook of any optional unit that may be installed, as
appropriate.
Message
Warning Low memory
Memory overflow. Press "Continue" to
resume job.
Data overrun. Press "Continue" to resume
job.
Printer board error.
Printer board error.
EEPROM
Printer board error.
ROM check-sum.
Printer board error.
RAM
System error.
Main switch off / on.
Printer Error. Press "Copy/Print" to resume
job
Opt. ROM error
Press CONTINUE
Interface occupied
Waiting FIT
KPDL error
Add paper in drawer. XX size
Add paper in bypass. XX size
22
The printer's internal memory is running low.
Turn the main switch OFF and then ON again and then try to print one more time. You
can check the amount of user memory currently available by printing a status page.
The printer memory has become full during reception of data for a print job. Press the
"CONTINUE" key to resume printing (the page may break in some Pages). You can
abandon printing by the "CANCEL" key.
Printing could not be accomplished correctly because the print job contains complex
data that could not synchronize with the printer engine. Press the displayed "Continue"
key to reprint the data.
There may be a problem with the Printer Board. Turn the main switch OFF and then ON
again, and then try to print one more time. If the error message remains even after
following the above procedure, contact your service representative, an authorized serv-
ice center or the place of purchase.
The interface selected is currently being used.
Repeat operations after a while.
Compressed data is printed due to insufficient memory. The quality of printed data is
reduced when this occurs. Turn the main switch OFF and then ON again and then try to
print one more time. If the error message remains even after following the above proce-
dure, contact your service representative, an authorized service center or the place of
purchase.
Current print processing cannot continue. You can abandon printing by the "Cancel" key.
The size of the original does not match the size of the paper loaded in the drawer. Load
paper of the size indicated into the drawer and press the displayed "Continue" key to
reinitiate the print job. To cancel the print job, press the "Cancel job" key.
The size of the original does not match the size of the paper set in the stack bypass tray.
Remove the paper, readjust the sliders and set paper of the size indicated. Then press
the displayed "Continue" key to reinitiate the print job. To cancel the print job, press the
"Cancel job" key.
Procedure