Displaying And Setting Paths - HP Visualize c100 Service Handbook

Displaying and Setting Paths

A path is the hardware address of a device that is
attached to the I/O system of your workstation. The
path command sets the system paths shown in Table
50.
Table 50 System Paths
primary or pri
alternate or alt
console or con
keyboard or key
To display the current settings for the system paths,
type the following at the prompt:
Path Type
Your workstation's default boot
device (usually the root disk)
Your workstation's alternate boot
device (usually a DDS-format tape
device)
Your workstation's primary display
device
Your workstation's primary ASCII
input device
path
Boot Console Interface
Displaying and Setting Paths
Device
149