Assigning Dma Channels For Isa Cards; Isa Cards And Hardware Monitor - Asus KN97 User Manual

III. INSTALLATION
To simplify this process this motherboard has complied with the Plug and Play (PNP)
specification which was developed to allow automatic system configuration when-
ever a PNP-compliant card is added to the system. For PNP cards, IRQs are as-
signed automatically from those available.
If the system has both Legacy and PNP ISA cards installed, IRQs are
assigned to PNP cards from those not used by Legacy cards. The PCI and PNP
configuration of the BIOS setup utility can be used to indicate which IRQs are being
used by Legacy cards. For older Legacy cards that does not work with the BIOS,
you can contact your vendor for an ISA Configuration Utility.
An IRQ number is automatically assigned to PCI expansion cards after those used
by Legacy and PNP ISA cards. In the PCI bus design, the BIOS automatically
assigns an IRQ to a PCI slot that has a card in it that requires an IRQ. To install a
PCI card, you need to set something called the INT (interrupt) assignment. Since all
the PCI slots on this motherboard use an INTA #, be sure that the jumpers on your
PCI cards are set to INT A.

Assigning DMA Channels for ISA Cards

Some ISA cards, both Legacy and PNP may also need to use a DMA (Direct Memory
Access) channel. DMA assignments for this motherboard are handled the same way
as the IRQ assignment process described above. You can select a DMA channel in
the PCI and PNP configuration section of the BIOS Setup utility.
IMPORTANT: Choose "Yes" for those IRQs and DMAs you wish to reserve
for Legacy (Non-PnP) ISA expansion cards in "IRQ xx Used By ISA" and "DMA
x Used By ISA" of the PNP and PCI Setup in the BIOS SOFTWARE section,
otherwise conflicts may occur.

ISA Cards and Hardware Monitor

The onboard hardware monitor uses the address 290H so legacy ISA cards must not
use this address or else conflicts will occur.
ASUS KN97-X User's Manual 27