Hunter 23710 Installation Instructions Manual page 4

B.
Lift the fan and position the (3) flanges in the canopy into
the (3) mating slots in the ceiling plate. Lift the fan until it is free
to rotate in either direction. Rotate the fan until the (3) larger
holes in the canopy line up with the (3) mating holes in the
ceiling plate. Using (3) 10 -32 x 1/2" long Phillips round head
screws, secure the canopy to the ceiling plate.
CAUTION: Failure to properly tighten the (3) screws could
result in the fan falling.
C.
Slide the canopy trim piece up to the top of the canopy and
align the (3) holes in the trim with the (3) mating holes in the
canopy. Using (3) 6-32 by 3/8" long countersunk head screws
assemble the trim to the canopy. See Figure 7. Snug the screws,
do not over tighten.
ASSEMBLY
SCREWS
NOTE: Check the hanger ball and make certain the (2) tabs in
the canopy are still engaged with the (2) grooves in the hanger
ball before operating the fan. See Figure 5D. If the tabs are not
engaged with the ball grooves you will need to re-align the tabs
before proceeding.
Step 8: Fan Blade Assembly, Installation,
and Balancing
A.
Attach blades to blade brackets using three screws for each
blade. See Figure 8. You must first insert the rubber grommets
into the holes in the blades. See Figure 8A.
NOTE: Grommets are usually assembled by hand. If you use a
tool, make certain you do not damage the grommet or blade
when inserting the grommets.
Figure 8
Next assemble the blade to the blade bracket. Make sure all
screws are tight to prevent vibration or wobbling.
NOTE: When the screws are tight, the blades may seem to be
loose. This is normal when using grommets and will not be a
problem.
FORM NO. 41184-01 10/05
CANOPY
Figure 7
BLADE
GROMMET
Figure 8A
B.
Remove the screws and rubber bumpers from the motor hub.
Insert a mounting screw (provided) in hole in blade bracket. Use
a screwdriver to hold in place. Align blade holes with mounting
holes in hub by turning screw and readjusting blade bracket until
screw mates with threaded hole in hub. Do not tighten until both
screws have been put in blade bracket. Repeat for all blades. See
Figure 9.
TRIM
C.
A blade balancing kit has been provided with your fan.
Should the fan wobble in operation, you may use this kit to cor-
rect the balance per the instructions supplied with the kit.
Step 9: Assemble Switch Housing
A.
Assemble lower switch housing to upper switch housing.
See Figure 10.
ASSEMBLY
SCREWS
POWER / ON-OFF
SWITCH
BREAKAWAY
CONNECTOR
First connect the upper and lower plug connectors. See Figure 10.
NOTE: The plug is polarized and will only go together one way.
Make sure you have correctly aligned both halves of the connector.
Next assemble the upper and lower switch housing using (3) 6-32
countersunk head screws. Make sure the (3) holes in both halves
of the switch housing line up with each other. You may have to
slightly rotate the blades to allow clearance to the assembly
screws. Snug the (3) screws, but do not over tighten or you could
strip the threads.
- -
4
BLADE MOUNTING
SCREWS
NOTE: MAKE CERTAIN ALL
SCREWS ARE TIGHT
Figure 9
UPPER SWITCH
HOUSING
UPPER PLUG
CONNECTOR
LOWER PLUG
CONNECTOR
LOWER SWITCH
HOUSING
REVERSING
SWITCH
Figure 10
©2005 HUNTER FAN CO.