Configuration - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual
Wireless access point 802.11g
Hide thumbs
Also See for WG302 - 802.11g ProSafe Wireless Access Point:
- Reference manual (112 pages) ,
- Configuration (3 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
Configuration
Figure 5-2: Advanced Wireless Settings screen AutoCell Setup options
There are two AutoCell configuration setting choices:
•
Enable/disable Auto RF Management: Enabled by default
•
Enable/disable Enhanced RF Security ('Stealth Mode'): Disabled by default
Auto RF Management
Note: Channel selection and power management is automatically adjusted by AutoCell
when the Auto RF Management option is enabled.
In this mode, AutoCell APs and clients load-balance traffic across under utilized APs. This mode
avoids interference from neighbors clients and APs and other unexpected sources.
Enhanced RF Security 'Stealth Mode'
Note: Broadcast Wireless Network Name (SSID) is automatically turned off when you
select the AutoCell Enhanced RF Security option.
In this mode, AutoCell shrinks the size of coverage to the minimum to reach clients but also
shrinks the size of the beacons that access points use to announce their presence. This mode makes
an enterprise wireless LAN nearly invisible to users outside an office building.
Advanced Configuration
July 2005 v3.0
5-3
Advertisement
Table of Contents
