Default Factory Settings - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302

Default Factory Settings

When you first receive your WG302, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
"WG302 front panel" on page
User Name (case sensitive)
Password (case sensitive)
(if DHCP server is unavailable)
Broadcast Network Name (SSID)
802.11g Radio Frequency Channel
AutoCell RF Management
AutoCell Enhanced RF Security 'stealth' mode
Restricting connectivity based on MAC Access
Time Zone Adjust for Daylight Saving TIme
Basic Installation and Configuration
2-6.
FEATURE
Operating Mode
Access Point Name
Built-in DHCP client
Built-in DHCP server
IP Configuration
Network Name (SSID)
WEP/WPA
Control List
Spanning Tree Protocol
Time Zone
SNMP
Secure Telnet
SugerG Mode
WMM Mode
July 2005 v3.0
FACTORY DEFAULT SETTINGS
admin
password
Access Point
netgearxxxxxx where xxxxxx are the last six
digits of the wireless access point's MAC address
DHCP client disabled
DHCP server disabled
IP Address: 192.168.0.228
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
NETGEAR
Enabled
11
Enabled
Disabled
Disabled
Disabled
Enabled
GMT
Disabled
Enabled but Trap forwarding is disabled
Enabled
Disabled
Disabled
3-3