How To Configure Wep - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual

Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
Choose to use the local MAC address database stored on the access point, or use the RADIUS
4.
MAC address database stored on a RADIUS server. If you choose the RADIUS MAC Address
Database, you must configure the RADIUS Server Settings first.
Then, either select from the list of available wireless cards the WG302 has found in your area,
5.
or enter the MAC address and device name for a device you plan to use. You can usually find
the MAC address printed on the wireless adapter.
Click Add to add the wireless device to the access list. Repeat these steps for each additional
6.
device you want to add to the list.
Be sure to click Apply to save your wireless access control list settings.
7.
Now, only devices on this list will be allowed to wirelessly connect to the WG302.

How to Configure WEP

To configure WEP data encryption, follow these steps:
Log in to the WG302 using its default address of
1.
address the unit is currently configured Use the default user name of admin and default
password of password, or whatever LAN address and password you have set up.
Click the WEP/WPA Settings link in the main menu of the WG302.
2.
Figure 3-11: Wireless Settings menu
Choose Open System or Shared Key authentication.
3.
Basic Installation and Configuration
http://192.168.0.228
July 2005 v3.0
or at whatever IP
3-21