Channel Message - Yamaha Sound Edge Manual

Appendix
CHANNEL MESSAGE (Reception)
NOTE ON/OFF
Note Number
Velocity
CONTROL CHANGE
(CONTROL NUMBER)
CHANNEL MODE MESSAGE
All SOUND OFF
RESET ALL CONTROLLERS
ALL NOTE OFF
RPN (Registered Parameter Number)
PITCH BEND SENSITIVITY
FINE TUNING
78
COARSE TUNING
NULL
PROGRAM CHANGE
GM VOICE
DRUM SET
SYSTEM EXCLUSIVE
GM LEVEL 1 SYSTEM ON
MIDI MASTER VOLUME
MIDI MASTER TUNING
C-2–G8
1–127
(PARAMETER)
1 Modulation 0–127
7 Volume 0–127
10 Panpot 0–127
11 Expression 0–127
64 Sustain 0–127
Message allows complete shut off of all sounds; however retains NOTE ON and HOLD ON channel messages.
Reset controller's value to default (below):
PITCH BEND
CHANNEL PRESSURE
MODULATION
EXPRESSION
HOLD
RPN
Message allows NOTE OFF of all occurring sounds, however when HOLD1 is ON, NOTE OFF will not occur until channel
(HOLD1) turns off.
BnH, 64H, 00H, 65H, 00H, 06H, mmH
mm:00H–18H (0–24 Semitones)
Default is 02H (2 Semitones)
BnH, 64H, 01H, 65H, 00H, 06H, mmH, 26H, llH
mm, ll: (00H, 00H)–(40H, 00H)–(7FH, 7FH)
-100cents +100cents
BnH, 64H, 01H, 65H, 00H, 06H, mmH
mm:28H -00H - 58H (-24 -0 -24 Semitones)
BnH, 64H, 7FH, 65H, 7FH
0–127–> VOICE1–VOICE128
CAH, xxH
xx:0 Standard
xx:8 Room
xx:10 Power
xx:18 Electronic
xx:19 Analog
xx:20 Jazz
xx:28 Brush
xx:30 Orchestra
Other Ignore
Default: Standard Set
F0H, 7EH, 7FH,09H, 01H, F7H
Message initializes all controllers to default except MIDI MASTER TUNING.
F0H, 7FH, 7FH, 04H, 01H, ll, mm, F7H
Message controlls volume on all channels at once.
Default value of mm is 7FH, II is ignored.
F0H, 43H, 1nH, 27H, 30H, 00H, 00H, mm, ll, cc, F7H
Message controls value on all channels at once.
mm II value equal to MIDI MASTER TUNING VALUE.
T=Mx200–256–100
M: 3bit of mm as MSB, 3 bit of II as LSB.
Byte value defined in numerics.
Defaults for mmII are 07H, 0FH.
n, c are optional.
These values will not be initialized even by GM LEVEL 1 SYSTEM ON or RESET ALL CONTROLLERS.
0 (CENTER)
0 (OFF)
0 (OFF)
127 (MAX)
0 (OFF)
RPN numbers undecided/Internal data will not change.