Table of Contents
Advertisement
Recording on the Time Lapse VTR
Confirm the REC MODE parameter. See page 9 for
details.
Note: When T/L is selected but no camera switching
signal is supplied, time lapse recording will not
work properly.
In this case, supply the camera
switching signal or set REC MODE to 4-255 FIELDS
for normal recording.
Monitoring the Playback Picture
Caution:
Set the time lapse VTR to the playback mode.
Recorded tapes should be played back in NOR-
MAL or TIME LAPSE for the time mode.
Notes:
• This unit does not reproduce a clear picture in
reverse playback.
• The playback picture may be skewed (horizon-
tally distorted) under certain circumstances,
but this does not indicate a malfunction.
• The picture or title may vibrate vertically
because they are recorded at field rate, but
this does not indicate a malfunction.
• Depending on the condition of the video
heads, the picture of a channel other than the
selected one may be displayed. If this occurs
frequently, adjust the tracking or slow-tracking
of the VTR. This usually eliminates the prob-
lem.
• The size of pictures displayed in quad format is
smaller than in single picture format, which
makes the titles hard to read. Select single
picture (spot) to make titles easier to read.
• While playing back a tape in forward or reverse
search, or a tape that has been recorded in
MULTISCR mode, the looped through video
may appear on the monitor.
• Playing back in linear mode (L12H, L18H,
L24H) may produce noise or the picture of the
other channel is reproduced on the monitor in
any recording mode of the time lapse VTR. In
this case, play back in normal mode (3H) or
time lapse mode.
A. Single Spot Picture
1. Operate the VTR in playback mode.
2. Set the MODE SELECT / CAMERA SELECT switch
to MODE SELECT.
3. Press button 8 (CAMERA / VTR). The CAMERA /
VTR indicator lights.
CAMERA/VTR
8
4. Set the MODE SELECT / CAMERA SELECT switch
to CAMERA SELECT.
5. Press one of the camera selection buttons to dis-
play the desired playback picture on the monitor.
The LED on that button lights up, and the selected
playback picture appears on the monitor.
-16-
ENTRANCE
Playback Picture
Advertisement
Table of Contents
