Table of Contents
Advertisement
Description of each menu
•
The default values listed in this manual, especially on pages 55-64, are
for reference only. They may vary between the projectors due to the
continuous improvement to the products.
FUNCTION
Wall Color
Aspect Ratio
2D Keystone
Corner Fit
Position
Phase
H. Size
Digital Zoom
DESCRIPTION
Corrects the projected picture's color when the projection
surface is not white. See
details.
There are four options to set the image's aspect ratio depending
on your input signal source. See
page 37
for details.
Corrects vertical and horizontal keystonings of the image. See
"Correcting 2D keystone" on page 29
Manually adjust four corners of the image by setting the
horizontal and vertical values. See
30
for details.
Displays the position adjusent page. To move the projected
image, use the directional arrow keys. The values shown on the
lower position of the page change with every key press you made
until they reach their maximum or minimum.
This function is only available when a PC signal
(analog RGB) is selected.
Adjusts the clock phase to reduce image
distortion.
This function is only available
when a PC signal (analog RGB) is selected.
Adjusts the horizontal width of the image.
This function is only available when a PC signal
(analog RGB) is selected.
Magnifies or reduces the projected image. See
searching for details" on page 36
"Using Wall Color" on page 39
"Selecting the aspect ratio" on
for details.
"Adjusting corner fit" on page
for details.
for
"Magnifying and
Operation
55
Advertisement
Table of Contents
