Dell 5330 User Manual page 125

Menu item
Alarms
Alarm Control
Cartridge Alarm
Staple Alarm
Timeouts
Job Hold Timeout
5–255 sec
Timeouts
Power Saver
1–240 min
Timeouts
Screen Timeout
15–300 sec
Description
Sets an alarm to sound when the printer requires operator
intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
Single is the factory default setting for Alarm Control. Single
•
sounds three quick beeps.
Off is the factory default setting for Cartridge Alarm and
•
Staple Alarm. Off means no alarm will sound.
Continuous repeats three beeps every 10 seconds.
•
Staple Alarm is available only when the finisher is installed.
•
Sets the amount of time the printer waits for user intervention
before it holds jobs that require unavailable resources and
continues to print other jobs in the print queue
Notes:
30 seconds is the factory default setting.
•
This menu item only appears when a printer hard disk is
•
installed.
Sets the amount of time the printer waits after a job is printed
before it goes into a reduced power state
Notes:
30 minutes is the factory default setting.
•
Lower settings conserve more energy, but may require longer
•
warm-up times.
Select the lowest setting if the printer shares an electrical
•
circuit with room lighting or you notice lights flickering in the
room.
Select a high setting if the printer is in constant use. Under
•
most circumstances, this keeps the printer ready to print with
minimum warm-up time.
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Understanding printer menus
125