Dell 2355 Mono Laser User Manual page 179

Configuring TCP/IP
• Static Addressing: TCP/IP address is assigned manually by the system administrator.
• Dynamic Addressing BOOTP/DHCP (default): TCP/IP address is assigned automatically
by a DHCP or BOOTP server on your network.
NOTE:
Setting TCP/IP
To enter the TCP/IP setting from your printer's operator panel, take the following steps:
Press Setup
1
Press the Next (
2
Press the up/down arrows to select Network Setup.
3
Press the up/down arrows until you see the desired protocol
4
If you selected TCP/IP (IPv4).
a
b
If you selected TCP/IP (IPv6).
a
b
Press the home icon (
5
Static Addressing
To enter the TCP/IP address from your printer's operator panel, take the following steps:
Press Setup
1
Press the Next (
2
Press the up/down arrows to select Network Setup.
3
Press the up/down arrows to select TCP/IP (IPv4).
4
Press the up/down arrows to select Set IP Address.
5
Select Configuration and press the left/right arrows to select Manual.
6
Select the IP Address menu.
7
An IP address consists of 4 bytes.
Press 1st byte area and enter the numbers using the keypad.
8
Enter the rest of the bytes in the same way.
Enter other parameters, such as the Subnet Mask or Gateway.
9
After entering all parameters, press the home icon (
10
178
Only the system administrator can set the IP address forTCP/IP (IPv6).
Machine Setup from the home screen.
) button.
Press IPv4 Activate.
Press the left/right arrows to change the setting to On (enable) or Off (disable).
Press IPv6 Activate.
Press the left/right arrows to change the setting to On (enable) or Off (disable).
) to return to the Standby mode.
Machine Setup from the home screen.
) button.
) to return to the Standby mode.