Table of Contents
Advertisement
NOTE:
You can improve the printing quality of envelopes by pulling down the rear door to
open and pushing the two blue pressure levers down. This instruction will be especially
helpful for DL and C5 size envelopes.
•
A combination of high humidity (over 60%) and the high printing temperatures may seal
the envelopes.
Labels
Your printer can print on many labels designed for use with laser printers. These labels are
supplied in letter size, A4 size, and legal size sheets. Label adhesives, face sheet (printable
stock), and topcoats must be able to withstand temperatures of 180° C (356° F) and pressure
of 25 pounds per square inch (psi). You can load one label sheet at a time in the MPF.
Try a sample of any label you are considering using with the printer before purchasing a large
quantity:
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting
in a jam. Partial sheets also contaminate your printer and your cartridge with adhesive,
and could void your printer and cartridge warranties.
•
Use labels that can withstand temperatures of 180° C (356° F) without sealing, excessive
curling, wrinkling, or releasing hazardous emissions.
•
Do not print within 0.04 in. (1 mm) of the edge of the label, of the perforations, or
between die-cuts of the label.
•
Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone
coating of the adhesive at least 0.04 in. (1 mm) away from edges. Adhesive material
contaminates your printer and could void your warranty.
•
If zone coating of the adhesive is not possible, a 0.125 in. (3 mm) strip should be
removed on the leading and driver edge, and a non-oozing adhesive should be used.
81
Advertisement
Table of Contents
Troubleshooting
