Front-Panel Leds (Rsp720, Rsp720-10Ge, Sup720, Sup32) - Cisco WS-SUP720-3B - Supervisor Engine 720 User Manual

Supervisor Engine 720 and Supervisor Engine 32
Table 2-8
Component
Status LEDs
Reset Button
CompactFlash
Disk Slots
Console Port
Uplink Ports
USB Ports (Sup32 only)

Front-Panel LEDs (RSP720, RSP720-10GE, Sup720, Sup32)

LEDs on the front panel of the supervisor engine or route switch processor show the status of the
processor and other components installed in the router.
Switch Processor 720 and RSP720-10GE, the Supervisor Engine 720, and the Supervisor Engine 32.
See
Table 2-9
LED
STATUS
SYSTEM
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
2-22
RSP720, RSP720-10GE, Sup720, and Sup32 Front-Panel Controls
Description
Indicate the status of various functions on the module (see
Restarts the router. Use a ballpoint pen tip or other small, pointed object to
access the Reset button. Not all modules have a Reset button.
One or two slots for flash memory cards. Do not remove the card from
the slot while the disk LED is on. See the
section on page 3-12
Provides access to the router. The port is an EIA/TIA-232 asynchronous,
serial connection with hardware flow control and an RJ-45 connector.
See the
instructions on connecting to the console port.
On the RSP720, the console port allows you to access either the switch
processor (SP) or the route processor (RP).
Used to connect the router to other network devices. The uplink ports are
configurable with SFP, XENPAK, or X2 optics modules. See the
"Connecting to the Uplink Ports" section on page 3-10
information.
Each USB port can function as a console port or security key.
Table 2-11 for a list of LED functions on the Supervisor Engine 2.
RSP720, Sup720, and Sup32 LEDs
Color
Green
Orange
Yellow
Red
1
Green
Orange
Red
Blinking
Red
Chapter 2
for information about working with flash memory.
"Connecting to the Console Port" section on page 3-9
Table 2-9
Description
All diagnostics pass; the module is operational (normal initialization
sequence).
The module is booting or running diagnostics (normal initialization
sequence).
Minor hardware problems.
An overtemperature condition occurred. (A major threshold has been
exceeded during environmental monitoring.)
All chassis environmental monitors are reporting OK.
The module is powering up or a minor hardware fault has occurred.
Major hardware problem.
The temperature of the supervisor engine or RSP has exceeded the major
temperature threshold.
Continuous backplane stall.
Route Switch Processors and Supervisor Engines
Table
"Using Flash Memory Cards"
for
for more
lists the LED functions on the Route
2-9).
OL-10100-11