Cisco WS-SUP720-3B - Supervisor Engine 720 User Manual page 22

Overview
Table 2-1
Specific combinations of processors and modules may not be supported in your chassis. See the release
notes for your software version for information about supported combinations.
Table 2-1
Product Number
Route Switch Processor 720
RSP720-3C-10GE
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide
2-4
lists the RSP and supervisor engine configurations supported on Cisco 7600 series routers.
Route Switch Processor and Supervisor Engine Configurations
Description
•
•
Note
•
•
•
•
•
•
Chapter 2 Route Switch Processors and Supervisor Engines
Two 10 Gigabit Ethernet (10GE) uplink ports support 10-Gbps X2
modules
Three Gigabit Ethernet (1GE) uplink ports: two ports support
1-Gbps small form-factor pluggable (SFP) module; one port
supports 10/100/1000-Mbps RJ-45 connector
Use Category 5 Shielded Twisted Pair cable at the port that
supports the10/100/1000-Mbps RJ-45 connector.
Integrated 720-Gbps switch fabric
PFC3C and MSFC4 with 512-MB bootdisk, 4-MB NVRAM,
4-MB ROMmon, and several DRAM options:
– Route processor (RP): 1- to 4-GB DRAM (default 1 GB)
– Switch processor (SP): 1- to 2-GB DRAM (default 1 GB)
One CompactFlash Type II slot (512 MB) on front panel and two
internal CompactFlash (512 MB each for RP and SP; you can
optionally increase external compact flash and each internal
CompactFlash to 1 GB)
Requires larger power supplies and a high-speed fan tray
QoS port architecture, 10GE ports (Rx/Tx): 8q8t/1p7q8t (CoS)
QoS port architecture, 1GE ports (Rx/Tx): 2q8t/1p3q8t
OL-10100-11